1-800-44-ENDOT(443-6368)
PIPE AND TUBING . DUCT AND INNERDUCT  

 

 

 

 

 

 

 FAQ
 Tech/Installation
 Request Support
 MSDS Documents
 Submittals

Technical

GENERAL

-All Endot potable water pipe is now produced with pe4710-bi-modal HDPE
-Bend Radius Calculations
-Cell Class
-Chemical Resistance (PDF Format)
-Crush Strength
-Friction
-Tensile Strength
-Thermal Conductivity and Expansion Rate of HDPE (PDF Format)
-Thermal Contraction of PE pipe tubing (PDF Format)

PIPE

-Application Notes Revised
-ASTM Sizing Standards (PDF Format)
-Chemical Resistance Chart
-EndoPure UV Technical Statements
-Geothermal U-BEND specs (PDF Format)
-Heating Cycles for Endot Gas Pipe
-Heat Fusion Times
-NSF vs Non-NSF Pipe for Irrigation Systems (PDF Format)
-Palletized/Stretch Wrapped Packaging
-Pipe Part Numbers (PDF Format)
-Pipe Selection Guide (PDF Format)
-Pipe Selection for Wells
-Pressure Drop in CTS Tubing
-Pressure Drop in CTS Tubing (PDF Format)
-Pressure Testing Pipe
-Pressure Drop in D2239 IPS Pipe
-Pressure Drop Per 100 Feet of Polyethylene Pipe
-Thermal Contraction
-Thermal Conductivity and Expansion Rate of HDPE
-Water Make-up Table 3 During Testing
-Water Flow Characteristics
-Water Pipe Part Number Chart (XLS Format)
-Water Volume in D3035 Pipe (PDF Format)

CONDUIT

-Innerduct Part Numbers (PDF Format)
-Innerduct Part Number Chart (XLS Format)
-UV Stability of Innerduct (PDF Format)
-UL 651 B Wire & Ambient Temp Ratings (PDF Format)

GAS
-Gas Flow Capacity Chart (PDF Format)
-Pipe Pressure Ratings by SDR & Design Factor
FUSION
Butt Fusion Time Cycle Guidleines
Socket Fusion Cycle Times
Additional Downloads
Using HDPE in Sanitary Sewers